刚体滑线又称钢体滑线，钢体滑触线产品特点

本产品有如下特点：

1、运行可靠，绝不发生电源中断故障。

刚体滑线

2、可使用于高温、高粉尘、高腐蚀气体等恶劣环境

3、机械强度大、不易弯曲变形，能耐受强大的短路冲击电流。

4、可根据用户需要设定载流量，更好大可达3000A以上，电压等级可达到5KV以上。

5、采用铜或铜铝导体，可大幅度降低导线电能损耗。

6、添加辅助电缆后，可组成低阻抗滑触线、导线阻抗成倍降低。

7、布线可在上部或下部滑触。

8、JGH-“I”型滑触线更有散热面特大，结构紧凑简单，安装维修方便等优点。

刚体滑线一般情况下按6m定尺长度供货。

刚体滑线绝缘支架安装间距一般为3m

Rigid sliding wire, also known as steel sliding wire, features of steel sliding contact wire products

This product has the following characteristics:

1. Reliable operation, never experiencing power interruption faults.

Rigid sliding line

2. Can be used in harsh environments such as high temperature, high dust, and highly corrosive gases

3. High mechanical strength, resistant to bending and deformation, capable of withstanding strong short-circuit impulse currents.

4. The current carrying capacity can be set according to user needs, with a maximum capacity of over 3000A and a voltage level of over 5KV.

5. The use of copper or copper aluminum conductors can significantly reduce the electrical energy loss of the conductor.

6. After adding auxiliary cables, low impedance sliding contact wires can be formed, and the wire impedance can be reduced by multiple factors.

7. The wiring can be slid on top or bottom.

8. JGH - "I" type sliding contact wire has advantages such as large heat dissipation surface, compact and simple structure, and convenient installation and maintenance.

The rigid sliding wire is generally supplied with a fixed length of 6m.

The installation spacing of rigid sliding wire insulation supports is generally 3m